ADC Home > Reference Library > Technical Q&As > Legacy Documents > Graphics & Imaging >
Legacy Document
Important: This document is part of the Legacy section of the ADC Reference Library. This information should not be used for new development.
Current information on this Reference Library topic can be found here:
|
NOTE: This Technical Q&A has been retired. Please see the Technical Q&As page for current documentation. |
|
|
Q: Do mesh contours run in the same or opposite direction as the face? For example, if the face runs clockwise, will the contour run counterclockwise? A: The exterior face needs to be defined in an anti-clockwise direction, but the contours defining holes can run in either direction. The mesh code is able to identify holes in a face. |