How to safely switch between mic configurations on iOS?

I have an iPadOS M-processor application with two different running configurations.

In config1, the shared AVAudioSession is configured for .videoChat mode using the built-in microphone. The input/output nodes of the AVAudioEngine are configured with voice processing enabled. The built-in mic is formatted for 1 channel at 48KHz.

In config2, the shared AVAudioSession is configured for .measurement mode using an external USB microphone. The input/output nodes of the AVAudioEngine are configured with voice processing disabled. The external mic is formatted for 2 channels at 44.1KHz

I've written a configuration manager designed to safely switch between these two configurations. It works by stopping AVAudioEngine and detaching all but the input and output nodes, updating the shared audio session for the desired mic and sample-rates, and setting the appropriate state for voice processing to either true or false as required by the configuration. Finally the new audio graph is constructed by attaching appropriate nodes, connecting them, and re-starting AVAudioEngine

I'm experiencing what I believe is a race-condition between switching voice processing on or off and then trying to re-build and start the new audio graph. Even though notifications, which are dumped to the console indicate that my requested input and sample-rate settings are in place, I crash when trying to start the audio engine because the sample-rate is wrong. Investigating further it looks like the switch from remote I/O to voice-processing I/O or vice-versa has not yet actually completed. I introduced a 100ms second delay and that seems to help but is obviously not a reliable way to build software that must work consistently.

How can I make sure that what are apparently asynchronous configuration changes to the shared audio session and the input/output nodes have completed before I go on?

I tried using route change notifications from the shared AVAudioSession but these lie. They say my preferred mic input and sample-rate setting is in place but when I dump the AVAudioEngine graph to the debugger console, I still see the wrong sample rate assigned to the input/output nodes. Also these are the wrong AU nodes. That is, VPIO is still in place when RIO should be, or vice-versa.

How can I make the switch reliable without arbitrary time delays?

Is my configuration manager approach appropriate (question for Apple engineers)?

How to safely switch between mic configurations on iOS?
 
 
Q